3D Printer Controller Board RAMPS 1.4 Shield

381.36 GST Excluding

Shield Specification:

  1. Operating Voltage : 12V
  2. Standard interfaces (as that of the extruder)
  3. Reserved GCI like I2C and RS232
  4. 3 MOSFET’s are applied to the heater/ fan and thermistor circuit
  5. Another 5A added to protect the component parts
  6. An 11A fuse is added to the hotbed
  7. Support 5 stepper drive board
  8. The adoption of Pin Header as Pololu makes it more convenient to repair or change
  9. I2C and SPI are reserved for expanding
  10. All the MOSFET can be controlled by PWM
  11. Use the interface of the servo motor to adjust the level of the printing platform automatically
  12. Adding an SD module for SD ramps module
  13. LED can indicate the status of the heater (the open and close of MOS)
  14. Expandable to control other accessories
  15. Pololu boards are on pin header sockets so they can be replaced easily or removed for use in future designs
  16. 2 stepper motor for Z axis in parallel
SKU: SRK-00210 Category:
error: Content is protected !!